Step-by-Step UDisplay System Installation Instructions

Before You Start

Your UDisplay package includes the following:

  • Decorative Awards Display
  • Hook panel with standoffs
  • Installation Hardware

Tools Required for Installation:

  • Phillips-Head Screwdriver or Drill
  • Level
  • Pencil

Step 1

Locate an area for your UDisplay; check to make sure sufficient wall space is available by holding your hook panel against the wall.

Step 2

Unscrew the standoff caps. Level the hook panel against the wall in desired location using a level. Push one of the screws provided through the pre-drilled holes and mark the wall to indicate where to install anchors.

Step 3

Install the anchors provided as necessary. (If installing onto wall studs, anchors are not needed; however, you will need to use a longer screw, which is not provided).

Step 4

Using the screws and standoffs provided, pass each screw into each of the standoffs and into the hanger board at the hole locations. Place hook panel onto the marked locations using the screws coming out the back of the board as you guide to connect to anchors.

Step 5

Using your drill/Phillips-Head screwdriver, tighten but DO NOT OVER TIGHTEN screws to wall. Align UDisplay onto standoffs and screw in standoff caps.

Step 6 (optional)

Additional acrylic shelf installs on top of panel.

Installation Video

Extension Panel Installation